Reely 20 77 60, Руководство по эксплуатации

Страница: 165 / 172

165
Possibility 1 – applies for "normal" gyros and "heading look" gyros:
You are using the gyro in normal mode and setting the mixer for two different flight modes/two different gyro sensitivi-
ties (e.g. hover flight and normal flight). Set a positive value (e.g. +50%) when setting the switch "idle UP" (fig. 1, pos.
8) forward and another positive value (e.g. +75%) when setting the switch to the rear. This way, you can switch
between two different gyros sensitivities in flight.
Possibility 2 – applies for "heading look" gyros only:
You are using the gyro in heading look mode and setting the mixer for two different flight modes/two different gyro
sensitivities (e.g. easy and extreme aerobatic flight). To do so, set a negative value (e.g. -50%) when setting the switch
"Idle UP" (fig. 1, pos. 8) forward and another negative value (e.g. -75%) when setting the switch to the rear. This way,
you can switch between two different gyros sensitivities in flight.
Possibility 3 – applies for "heading look" gyros only:
You are using the gyro in both normal as well as heading look mode and setting the mixer for two different flight modes/
two different gyro sensitivities (e.g. hover flight, normal flight or aerobatic flight). To do so, set a positive value (e.g.
+50%) when setting the switch "Idle UP" (fig. 1, pos. 8) forward and a negative value (e.g. -75%) when setting the
switch to the rear. This allows you to switch between two different gyro sensitivities in flight, and between two different
gyro control characteristics at the same time.
Whether or not you can adjust your gyro’s heading look mode through your remote control with a positive
or negative value also depends on the type of gyro used. Sometimes, the positive or negative values must
be chosen differently than indicated in these instructions. Observe the operating instructions for the gyro
or try it out.
To choose this function, first switch on the transmitter. Press the "UP" and "DN" buttons at once The display shows the
screen indicated in figure 51.
Use the "UP" and "DN" buttons to select the following servo functions.
G1 = Setting for switch "Idle UP" forward
G2 = Setting for switch "Idle UP" backward
The standard value is 0.
With the buttons "INC" or "DEC", you can adjust the values between -100
and 100.
Figure 51
Figure 52