X2 COMBAT Install Guide 2.0
10
ii. Safety guide
1.
Installation of this system should be carried out by suitably trained and qualified technicians in accordance
with local electrical codes.
2.
To prevent the risk of electric shock do not expose the electrical connectors on the camera or the inside of the
control box to water before or during installation. Condensation/ misting may occur if water is allowed to
enter the housing before power is applied.
3.
Do not drop the product.
4.
Avoid the use of alcohol or solvent-based cleaners. The product should be cleaned with clean water and non-
abrasive material.
5.
The camera system should be installed where it cannot be tampered with by unauthorised personnel.
6.
The products should be securely fastened to a structure of sufficient strength to support it. Allowance should be
made for additional loads caused by local wind effects.
7.
This camera has been manufactured with passive moisture-removal measures, to protect the camera during
shipping/ transit. Do not remove the rear screw-cap at any time; this is for factory access only. For best results, it is
recommended once installed, that the camera be powered as soon as possible, to allow the internal heater and fan
devices to operate. It is not recommended to leave the camera in storage or unpowered for extended periods of
time.
THIS CAMERA SYSTEM MUST BE INSTALLED, OPERATED AND MAINTAINED
IN ACCORDANCE WITH THE
MANUFACTURER’S SPECIFICATIONS.
