X2 COMBAT Install Guide 2.0
14
2.0 Power supply installation & setup
The camera warranty is void unless it is installed using a Redvision power supply unit (PSU) and a
Redvision supplied umbilical/multicore lead (Composite cable). Using the wrong type of 3rd party
PSU could compromise safety and damage the camera unit.
UMBILICAL CABLE:
A pre-made composite cable with connector must be purchased with all
Redvision cameras. The female connector connects directly to the male connector on the base
of the Camera housing.
•
Mount the Redvision PSU in a position so it cannot be interfered with intentionally or
accidentally. Ideally use a lockable cabinet.
•
Securely fix the Redvision PSU using appropriate size screws and ensure the cable glands
have sufficient clearance to allow the cables to enter.
•
Ensure cable glands face downwards at all times, and securely tightened.
•
All cables should be channelled through the appropriately sized gland holes.
•
Only use Redvision supplied umbilical/multicore cables for connecting the X2 COMBAT
PTZ camera and Redvision PSU. Warranty will be void if these cables are extended
between the camera and PSU. Extending cables could also compromise safety. Contact
Redvision Technical Support if in doubt.
Follow the colour coding idents as shown in the table on page 13 for terminating the
umbilical/multicore cable in the power supply.
2.1 Power supply specifications
Power input voltage range
90-260 VAC
Frequency range
47Hz~63Hz
Output Voltage
24VDC
Max. output current
3.1A
Max. output power
75W
Operating temperature range
-40°C~60°C
WARRANTY & SAFETY NOTICE:
DISCONNECT ALL POWER BEFORE
OPENING OR WORKING ON THE POWER SUPPLY UNIT. INSTALLATION
MUST BE CARRIED OUT BY A SUITABLY QUALIFIED PERSON
