Redvision VEGA 2010-PW, Руководство по установке

Страница: 8 / 30

Vega 2010 Installation Guide
Version 1.0
8
©Redvision CCTV Ltd. 2018 Content subject to change without prior notification. All rights reserved.
3.0 Installation
It is strongly recommended that the camera/lens assembly is fitted indoors, before the housing is installed. All attempts should
be made to avoid damp air entering the housing enclosure, before sealing and powering. Failure to observe this advice may
result in condensation forming on the housing window, causing obscuration of the camera image.
3.1 Wall Bracket (Standard fitting):
•
Use the three mounting holes to fix the bracket to the wall (Fig 1); the bracket can be removed from the housing body
to aid fixing, by removing the Pivot Ball (shown below). The upper-left and bottom holes are elongated to aid levelling
during fixing.
•
Two cable entry points are provided (fig 2); at the rear of the baseplate (25mm ᴓ hole), for cables passed through the
wall, and at the front; located at the bottom of the wall arm cover (20mm threaded for conduit). A screw cap is
supplied for this access point, in the event it is not used.
Mount holes
Rear cable entry point
Front cable entry point (20mm)
Fig 1
Fig 2