Redvision VEGA 2010-PW, Руководство по установке

Страница: 17 / 30

Vega 2010-PW Installation Guide Version 1.5 June 2019
17
©Redvision CCTV Ltd. 2018 Content subject to change without prior notification. All rights reserved.
•
The CHAT™ board (Fig 11) provides 12VDC power output to power a camera and lens assembly (Ethernet connection is
for data only). The 12VDC output is rated at 1.8A. Please ensure that this is not exceeded, or damage could occur.
•
The CHAT
TM
interface board is secured to one side of the housing interior. To gain access to the camera mounting
plate; first remove the two retaining screws holding the CHAT
TM
board in place (Fig 12, above). Gently lift the CHAT
TM
board out of the housing (there will be fixed wires for the wiper attached) to reveal the camera mounting plate:
•
The camera baseplate is secured by 4 screws. The baseplate sits on 4 mount posts. Each post is stepped, allowing 2
mounting height options. The baseplate itself can also be inverted, allowing 4 different heights in total. This allows for a
wide variety of cameras and lens combinations to be used, whilst still retaining full vision through the window without
obscuration.
Fig 17 2 retaining screws securing CHAT
TM
Interface board