Redvision VEGA 2010-PW, Руководство по установке

Страница: 18 / 30

Vega 2010-PW Installation Guide Version 1.5 June 2019
18
©Redvision CCTV Ltd. 2018 Content subject to change without prior notification. All rights reserved.
•
Remove the 4 screws and fix the camera to the baseplate using the ¼” UNC bolt supplied in the p arts kit. Position so
that the lens is close to the housing window. Use the baseplate and the stepped mount posts to allow optimum
placement of the camera. Best placement allows a slight gap between the lens and the housing window; to allow hot
air from the heater to rise and keep the lens and window clear at all times.
4.30 Connecting the camera & lens assembly
•
The CHAT
TM
board will already have some connections fitted. These are:
o
Heater
o
Wiper
o
12VDC (for camera power) – 1.8A maximum
o
RS-485 (for Wiper and relay control)
o
Cat 5e flying lead (for camera data only)
You should not need to change or move these connections. A set of auxiliary connection cables is supplied with the camera; a 6-
wire cable for auxiliary control and a 2-wire cable (Red/Black) for 12VDC or 24VAC power input to the board. Please connect
these cables carefully to avoid damage.
•
Connect the camera using the 12VDC pair and the Cat 5e flying lead.
Note: The PoE+ power input is to power the CHAT
TM
board only. It will not power the camera. A separate 12VDC output
(1.8A) is provided for this function. The flying Cat 5e lead is for camera data connection only.