RedMax AN-100U, Руководство пользователя, Страница: 53 / 106

Red MAX
™
Base Station
user manual
Doc. #70-00058-01-01-DRAFT Proprietary Redline Communications © 2006 November 29, 2006
Page 53 of 106
Hi : Highest priority setting of range.
VlanId : Ethernet packet 802.1Q VLAN tag. Valid only if Cs Specification is 802.1Q.
IP Prot. : IPv4 specification. Valid only if Cs Specification is IPv4.
EnetProtocol : When displayed, classification is based on this Ethernet protocol.
Tos : Matching parameters for the IP type of service/DSCP (IETF RFC 2474). An IP type
of service (ToS) packet will match if the "ip-tos" value, after the mask is applied, is equal
to, or falls between, the high and low range setting. Valid settings are zero to seven (0 to
7).
Low : Lowest priority setting of range.
Hi : Highest priority setting of range.
Mask : A logical 'AND' is performed using the mask and the "ip-tos" value before
testing for range.
SrcIp : IPv4 source address.
Addr Mask : Valid only if Cs Specification is IPv4.
DstIp : IPv4 destination address.
Addr Mask : Valid only if Cs Specification is IPv4.
SrcPort : IPv4 source port address. Valid only if Cs Specification is IPv4.
Start : Lowest port address in range.
End : Highest port address in range.
DstPort : IPv4 destination port address. Valid only if Cs Specification is IPv4.
Start : Lowest port address in range.
End : Highest port address in range.
Show : Click Show to display the setting for the service flow selected in the Service
Flow Identifier field.
ShowAll : Click ShowAll to display settings for all service flows.
HideAll : Click HideAll to hide settings for all service flows.