Redline Communications RDL-2000, Руководство по установке

Страница: 39 / 52

RDL-2000 Installation Guidelines
70-00144-01-01 Proprietary Redline Communications © 2011 Page 39 of 52 March 9, 2011
4.5.5 Step 5: Configure the RDL-2000
This step describes using the system configuration and monitoring options available
using the Redline Link Manager application. This application provides all settings
necessary to configure, monitor, and troubleshoot operation of the RDL-2000 wireless
link. The operator can access and control the RDL-2000 locally or remotely using IP
connectivity over the network connection. The CLI interface is a general monitoring tool
and does not include all commands necessary to setup and monitor the RDL-2000.
4.5.6 List of Required Parameters
The following table summarizes the steps required to configure the RDL-2000 unit.
Parameters must be configured in the stated order. Enter all parameter settings on each
screen and then click the Submit button to save these changes. If the unit automatically
reboots, start a new session and continue with the next step. Changing screens without
clicking the Submit button will discard all changes made in that screen.
The RDL-2000 must have a license file installed before placing unit in-service.
After changing the license file, you must exit and re-start the Link Manager application.
Table 12: Installation - Step by Step Configuration of RDL-2000
Step Screen Parameter Reference Master Slave
1 License License File
1
MAC Address
2 Link Channel BW
2
RF Plan
Config Unit Type
2
PTP Master PTP Slave
Enable MIMO
Enable Enable
MU ID RF Plan N/A
SU MAC Address MAC Address N/A
Channel Network Plan N/A
Enable ACS
Disable
N/A
3 Advanced Activate ATPC
Enable Enable
Band RF Plan
Adaptive Modulation
Enable
N/A
Antenna Gain RF Plan
M. Tx Power RF Plan
4 Installation IP Address Network Plan
Subnet Mask Network Plan
MU ID Network Plan N/A
RF Channels RF plan N/A
1
. After changing the license file, you must exit and re-start the Link Manager
application.
2
. When changing the Unit Type and/or Channel BW, you must click the Submit
Parameters button to make these changes active before continuing with the
configuration setup. The RDL-2000 unit will reboot.
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299