-
4
-
3. Warnings and safety notes
• Never leave the charger unsupervised when it is connected to a power supply.
If any error is observed immediately terminate the process and refer to the
instruction manual.
• Keep the unit free from dust, damp, rain, heat, direct sunlight and vibration.
• The circuit of the unit is designed to be powered by a 10-18V DC only.
• This unit and the battery to charge or discharge should be set up on a heat-
resistant, non-
flammable and non-conductive surface. Never place on a car seat,
carpet or similar. Keep all the
flammable volatile materials well away from the
operating area.
• If the charger program is set incorrectly it could cause severe damaged to the
battery and/or severe injury..Please ensure you have identified your battery correctly
• To avoid short-circuits between the charge lead, always connect the charge cable
voltage level:1.2V/cell
allowable fast charge current:1C~2C depends on the
l
e
v
e
l
f
f
o
t
u
c
e
g
a
t
l
o
v
e
g
r
a
h
c
s
i
d
l
l
e
c
f
o
e
c
n
a
m
r
o
f
r
e
p
0.85V/cell(NiCd), 1.0V/cell(NiMH)
voltage level:3.6V/cell
max.charge voltage:4.1V/cell
allowable fast charge current: 1C or less
min.discharge voltage cut off level:2.5V/cell or higher
voltage level:3.7V/cell
max.charge voltage:4.2V/cell
allowable fast charge current: 1C or less
discharge voltage cut off level:3.0V/cell or higher
voltage level:3.3V/cell
max.charge voltage:3.6V/cell
allowable fast charge current: 4C or less(e.g. A123M1)
discharge voltage cut off level:2.0V/cell or higher
voltage level:2.0V/cell
(Lead-acid) max.charge voltage:2.46V/cell
allowable fast charge current:0.4C or less
discharge voltage cut off level:1.50V/cell or higher
NiCd/NiMH
Li-ion
LiPo
Life
Pb
to the unit
first and only then to the battery to be charged or discharged. Reverse the
sequence when disconnecting.
•
Do not attempt to disassemble the battery pack.
Содержание SPIDER 1s
Страница 5: ...2 Exterior of the unit Input power cable AC100 240V 3...
Страница 22: ...Note...
Страница 23: ...RoHs...
