RedbacK Racing SPIDER 1s, Руководство по эксплуатации

Страница: 12 / 23

This shows the number of cells you set up and how
many cells the processor detects. ‘R:’ shows the number
of cells found by the charger and ‘S:’ is the number of cells
selected by you in the previous screeen. If both
numbers are identical you can start charging by press
Start/Enter button. If not, press Batt Type/Stop button
to go back to the previous screen. Then carefully check
the number of cells of the battery pack to charge again.
This screen shows the present status during the
charging process. To stop charging press
Batt Type/Stop key once.
6.2 Charging Lithium batteries in balance mode
This is for balancing the individual cell voltages of Lithium batteries. The battery pack
to be charged should be connected to one of the balance ports on the right side of the
charger. Also you need to connect the battery output plugs to the output of the charger.
In this mode, the internal processor of the charger will monitor the voltages of each cell
of the battery pack and controls the current fed to each cell to normilse the voltage.
This shows the number of cells you set up and how
many cells the processor detects. ‘R:’ shows the number
of cells found by the charger and ‘S:’ is the number of cells
selected by you in the previous screeen. If both
numbers are identical you can start charging by press
Start/Enter button. If not, press Batt Type/Stop button
to go back to the previous screen. Then carefully check
the number of cells of the battery pack to charge again.
This screen shows the present status during the
charging process. To stop charging press
Batt Type/Stop key once.
The left side of the first line shows the type of battery you
selected in users setting. The value on the left side of the
second line sets the charge current and the value on the
right side of second line sets the voltage of the battery pack.
After setting the current and voltage press Start/Enter
key for more than 3 seconds to start charging.
(Charge current:0.1~7.0A, Voltage 1~6 series)
The value on the left side of the second line sets a charge
current and the value on the right side of second line
sets the voltage of the battery pack.
After setting the current and voltage press Start/Enter
key for more than 3 seconds to start the process
(Charge current:0.1~7.0A, Voltage:1~6 series)