RedbacK Racing SPIDER 1s, Руководство по эксплуатации

Страница: 10 / 23

-
8
-
NiMH/NiCd SENSITIVITY:
This screen shows the D e l t a P e a k s e n s i t i v i t y of
NiMH and NiCd batteries. The values range from
5 to 20mV per cell. If the sensitivity is set higher there
is a possibility of overcharging the battery, a lower setting
may result in undercharging the cells. Please refer to below
recommendations (NiCd default:12mV, NiMH default:7mV)
NiMH/NiCd SENSITIVITY:
You can select the function of 3-pin port at left side of
the unit.It can be used temperature sensor port or USB
port, selected at this screen. If the port is assigned as
a temp. port, an optional temperature probe contacting
the surface of battery can be used. When it is selected
as an USB port, you can link the charger to your PC
via an optional USB cable. This can utilize the optional
software that can show you the charge process at PC.
You can set the maximum temperature at which the
charger should allow battery to reach during charge.
Once a battery reaches this temperature during
charge, the process will be terminated to protect the
battery.
WASTE TIME:
During cyclic process of charge and discharge
T h e b a t t e r y can often become warm.
You can set a time delay between each charge/discharge
cycle. To allow the batter to cool down before the next
cycle. The values range from 1 to 60 minutes
SAFETY TIMER:
When you start a charge process, the integral safety
timer automatically starts running at the same time.
This is programmed to prevent overcharge the battery
if it proves to be faulty, or if the termination circuit
cannot detect a full battery. The value for the safety
timer should be generous enough to allow a full charge
of the battery .