2
8.
NEVER SMOKE OR ALLOW A SPARK OR FLAME NEAR A BATTERY AS THESE MAY CAUSE THE BATTERY
TO EXPLODE. TO REDUCE THE RISK OF A SPARK NEAR A BATTERY WHEN CONNECTING THE BATTERY
INSTALLED IN A VEHICLE TO THE TVMS, ALWAYS DO THE FOLLOWING:
Wire the Output Connector before connecting it to the Distribution Box. During connection of the unit, the
Battery Output (positive) must be connected fi rst, followed by the Ground (chassis) terminal. The chassis
connection should be made away from the battery and fuel lines. Once all connections are wired to the
Output Connector, plug the connector into the Distribution Box.
9.
Do not use this product to control safety critical devices or those that could cause harm if operated remotely
(for example fume exhaust fans or lifters).
10. Ensure that the Display is not mounted in vehicle head-impact zones. Doing so may result in injury to the driver
and/or passenger in the event of an accident.
11. Ensure the Display is not mounted where it may distract the driver of the vehicle. Distracting the driver may
result in an accident.
12. Risk of damage to the system. Do NOT connect a load negative (-) to the chassis AND to the applicable negative
(-) output channel as this may cause damage to the Distribution Box under some circumstances. Connect to the
applicable negative (-) output channel OR a suitable chassis grounding point to avoid damage.
13. Risk of damage to the system. Do NOT connect to the ‘TRC’ socket at the front (240V end) of the inverter as
this will cause damage to the RedVision Distribution Box. Connect to the ‘REMOTE’ socket to avoid damage.
1.
Do NOT connect computers or IT equipment to the RJ45 ports on the RedVision Distribution Box or Display.
Damage may occur.
2.
It is recommended to leave the Display connected at all times to the base unit.
3.
The Distribution Box may be mounted in any orientation but must be mounted onto a fl at, solid surface using
4 x M6 screws or bolts. Failure to adequately mount the unit, such as using adhesives to mount the unit will
result in unreliable operation of the Distribution Box.
4.
It is the installer’s responsibility to ensure their installation complies with any applicable legal and regulatory
requirements. Within Australia, installers may wish to consult AS/NZS 3001 as one potentially relevant standard.
5. Ensure that the channel and master override dip-switches are turned off after use to prevent accidental
operation of the channel / fl attening of either the Starter or Auxiliary battery.
6.
The RedVision App and its interactions with RedVision has not been tested on all smartphones available on
the market so is not guaranteed to work on all devices. However, the app should work on most phones with
Bluetooth
®
4.0 (or later) running IOS 11. 1 (or later) or Android 7.0 (or later).
7.
The Confi gurator App. allows modifi cation to the core system functionality of your RedVision system, only use
this App if you have read and fully understand all instructions in this manual.
