INSERT A BATTERY
To insert a RED BRICK, REDVOLT-V, or other standard V-Lock battery in the DSMC2 V-Lock Battery Module Pro,
follow the instructions below:
1. Install the DSMC2 V-Lock Battery Module Pro. For more information, go to
"Install the DSMC2 V-Lock Battery
Module Pro" on the previous page
2. Align and insert the battery.
3. Apply pressure to the battery until a click is heard, signaling the battery is properly seated.
REMOVE A BATTERY
To remove a RED BRICK, REDVOLT-V, or other standard V-Lock battery from the DSMC2 V-Lock Battery Module Pro,
follow the instructions below:
1. Press the
Eject
button to the left of the DSMC2 V-Lock Battery Module Pro.
2. Remove the battery.
CHARGE BATTERIES WITH THE DSMC2 V-LOCK BATTERY
MODULE PRO
The DSMC2 V-Lock Battery Module Pro can charge one (1) RED BRICK, REDVOLT-V, or other standard V-Lock
battery, but only when the camera is off. When the camera is on, power defaults to the DC IN rather than the attached
battery. The DSMC2 V-Lock Battery Module Pro can charge a fully discharged RED BRICK in approximately 10.4
hours and a REDVOLT-V in approximately three (3) hours.
To charge a RED BRICK, REDVOLT-V, or other standard V-Lock battery with the DSMC2 V-Lock Battery Module Pro,
follow the instructions below:
1. Turn off the camera.
2. Attach the DSMC2 V-Lock Battery Module Pro to the BRAIN or expander.
3. Connect the DSMC AC Power Adaptor to the DC IN port on the DSMC2 V-Lock Battery Module Pro.
NOTE:
The battery does not charge if the power source is connected to the DC IN port on a separate expander.
4. Insert the battery into the DSMC2 V-Lock Battery Module Pro.
WARNING:
DO NOT use the DSMC2 V Lock Battery Module Pro as a desktop charger. This may cause damage to
the rear connectors on the module and is not covered under warranty.
C O PYR I G HT © 2 0 1 7 R ED.C O M , LLC
9 5 5 - 0 0 3 8 , R EV - AD
|
5 9
RED DSMC POWER OPERATION GUIDE
