Red Seal Measurement Datamate 2200, Руководство по эксплуатации и техническому обслуживанию

Страница: 100 / 128

Datamate 2200 O&M
Page 94
Menu or Display Description
Use the UP or ACROSS key to adjust the response time of the measurement in
seconds.
Damp Factor
[XXXXXXXXXXXX]
Configure Xmit Vars Press ENTER to configure Concentration, Brix or Baume Tables.
4. Concent./Solids
Use the UP or ACROSS key to select engineering unit to display Concentration. The
table that will be entered, should have the relation between temperature, density and
the unit selected here (%, Brix, Be Lt or Be Hv).
Unit
[XXXX ]
Use the UP or ACROSS key to set the fallback value in the event of a fault condition.
Fallback
[XXXXXXXXXXXX]
Use the UP or ACROSS key to set the visual Low Alarm Setpoint.
Low Alarm SetPnt
[XXXXXXXXXXXX]
Use the UP or ACROSS key to set the visual High Alarm Setpoint.
Hi Alarm SetPnt
[XXXXXXXXXXXX]
If this is a new table it is recommended to clear the entire table before entering the
new data. In the case only an edition of the table is needed select NO.
Clear Entire Table
[XXX]
The Table will hold a maximum of 14 pairs of Density and Concentration for 5
different operating temperatures. The Ref Temperature menu will repeat, after the
list of densities and concentrations is entered for the specific temperature, until the
5 different temperatures are set sorted by value. Use the UP or ACROSS key to set
the temperature.
Ref Temperature X
[XXXXXXXXXX]
The following two menus will repeat, until CANCEL is pressed or after 14 Density
and Concentration pairs are entered. Use the UP or ACROSS key to set the
Measured Density. The density should be entered sorted from the lower to the higher
value.
TMPX:X.X — Entry Point XX — Measured Density
[XXXXXXXXXX]
Use the UP or ACROSS key to set the corresponding Concentration for the above
entered density.
TMPX:X.X — Entry Point XX — Concent./Solids
[XXXXXXXXXX]