Red Hat ENTERPRISE LINUX 3 - FOR X86-ITANIUMTM-AMD64 AND INTEL EXTENDED MEMORY 64 TECHNOLO, Руководство по установке

Страница: 31 / 120

Chapter 4. Installing Red Hat Enterprise Linux 19
4.3.3. Additional Boot Options
While it is easiest to boot using a CD-ROM and perform a graphical installation, sometimes there
are installation scenarios where booting in a different manner may be needed. This section discusses
additional boot options available for Red Hat Enterprise Linux.
For Itanium users:
To pass options to the boot loader on an Itanium system, enter the following at the EFI Shell prompt:
elilo linux option
For x86, AMD64, and Intel® EM64T users:
To pass options to the boot loader on an x86, AMD64, or Intel® EM64T system, use the instructions
as provided in the boot loader option samples below.
Note
Refer to Appendix F Additional Boot Options for additional boot options not covered in this section.
•
To perform a text mode installation, at the installation boot prompt, type:
linux text
•
ISO images have an md5sum embedded in them. To test the checksum integrity of an ISO image,
at the installation boot prompt, type:
linux mediacheck
The installation program will prompt you to insert a CD or select an ISO image to test, and select
OK
to perform the checksum operation. This checksum operation can be performed on any Red
Hat Enterprise Linux CD and does not have to be performed in a specific order (for example, CD #1
does not have the be the first CD you verify). It is strongly recommended to perform this operation
on any Red Hat Enterprise Linux CD that was created from downloaded ISO images. This command
works with the CD, DVD, hard drive ISO, and NFS ISO installation methods.
•
Also in the
images/
directory is the
boot.iso
file. This file is an ISO image than can be used to
boot the installation program. It is a handy way to start network-based installations without having
to use multiple diskettes. To use the
boot.iso
, your computer must be able to boot from its CD-
ROM drive, and its BIOS settings must be configured to do so. You must then burn the
boot.iso
file onto a recordable/rewriteable CD-ROM.
•
If you need to perform the installation in serial mode , type the following command:
linux console= device
For text mode installations, use:
linux text console= device
In the above command,
device
should be the device you are using (such as ttyS0 or ttyS1).
For example,
linux text console=ttyS0
.
Text mode installations using a serial terminal work best when the terminal supports UTF-8. Under
UNIX and Linux, Kermit supports UTF-8. For Windows, Kermit ’95 works well. Non-UTF-8 capa-
ble terminals will work as long as only English is used during the installation process. An enhanced
serial display can be used by passing the
utf8
command as a boot-time option to the installation
program. For example:
linux console=ttyS0 utf8