Rebel AMIGO 3i, Руководство по сборке и эксплуатации

Страница: 56 / 64

41.5 Leak test
Leak testing is always required in the following
cases:
• Before first-time ignition of the barbecue.
• Every time a new gas cylinder is installed or
some component replaced.
• We recommend performing the test at least
once a year, before every barbecue season.
Always carry out the leak test outdoors, away
from heat, open flame, and combustible liquids.
Do not smoke while performing the test. Always
use 50/50 liquid soap/water solution for leak
testing. Never use a match or open flame.
41.6 Always check the following when
carrying out a leak test
• Gas cylinder valves and cylinder thread.
• All gas cylinder welds.
• Regulator mounting and gas cylinder
connections.
• All hose joints (including side burner hoses, if
present).
41.7 Carry out leak testing as follows
• Use a recently filled and checked gas cylinder
connected to the barbecue with all of the
barbecue connectors in the OFF position.
• Open the pressure regulator.
• Using a brush and soap/water solution, wet all
of the connections and components specified in
step 40.6.
•
Check carefully for bubbles (signs of gas
leakage).
• If bubbles appear next to connections, tighten
the connections until retesting shows no sign
of leakage (always turn off gas supply for the
duration of leakage repairs).
• Close the pressure regulator and make sure the
control valves are closed.
Do not use the barbecue if you fail to eliminate a
leak. Close the gas cylinder valve, detach the gas
cylinder and contact the importer.
42. USING THE BARBECUE
42.1 Ignition by battery operated piezo-
igniter
1. Always open the barbecue lid before igniting a
burner.
2. Turn on gas supply from the cylinder and low-
pressure regulator.
3. Press control knob to bottom and turn it
anticlockwise till position.
4. Push ignition button until burner ignites.
5. Adjust the burner flame by turning the
controller between high and low power.
6. After the burner has ignited, the rest of the
burners can be ignited by turning the
corresponding control knobs counter-
clockwise.
If burner does not ignite, see troubleshooting
table, or ignite with long match.
42.2 Lighting by match in case of piezo igniter
failure
Grill firebox’s right side has open hole, where
grill can be ignited with long match.
1. Always open the lid before lighting the
barbecue.
2. Turn on gas supply from the cylinder and low-
pressure regulator.
3. Though firebox’s open hole place a burning
match next to the burner.
4. Push and turn right side control knob till
position. Make sure by looking through the
grid and heat distribution panel that the burner
has definitely ignited.
If the burner still does not ignite, see the
troubleshooting table for help.
Warning! Never lean over the barbecue when
lighting or using it.
If the burner does not ignite in 10 seconds in spite
of repeated attempts, turn off the barbecue
controller and cut gas supply from the cylinder.
Leave the lid open and wait for at least 5 minutes
before re-attempting to light the barbecue. This
way, the gas accumulated in the barbecue can
escape.
54