Connect the rod end back to the control horn
and check the alignment to ensure it lines up
closely.
Iterate through the previous two steps until it
is aligned as close as possible.
Disconnect the battery from the ESC.
Apply the small velcro to the ESC and
receiver. On the ESC, it is desirable to apply
the velcro to the side that is not perfectly flat.
The flat side is the heat sink and should be
left open.
Place veclro in the plane and mount to the
side of the fuselage to hold the two items in
place.
The included battery should be placed as far
forward as possible and held with velcro. The
battery position will be adjusted forward and
backward to get the proper center of gravity
(CG).
© 2011/2012 Ready Made RC, LLC
