Dispose of the instruction manual (4).
Caution: Using with a chimney starter for
grilling is not recommended as the stench
from the paper is overwhelming.
Pull the receiver out of the battery
compartment in the transmitter (12). While
the battery cover is off, install 8 AA batteries
following the polarity shown in the
compartment.
The transmitter and receiver should be bound
from the factory. If for any reason a re-bind is
necessary, see page 14 for instructions on how
to bind the receiver to the transmitter.
With the antenna at the left of the receiver, the
6 channels are configured as follows:
(top)
1. Ailerons
2. Elevator
3. Throttle
4. Rudder
5. Gear (not used)
6. Flap (not used)
7. Bind port
Center the trims for the elevator, rudder, and
aileron. The throttle trim should be in the
lowest position to allow the Electronic Speed
Control (ESC) to arm when power is applied.
The radio system will be used in the setup of
the plane so set it aside after setting the trims
properly.
1
.
.
.
.
B
Throttle
Rudder
Aileron
Elevator
© 2011/2012 Ready Made RC, LLC
