Enabling and disabling ATIS mode
ATIS is a European system used on some inland
waterways. A unique ATIS ID must be entered to use
ATIS mode.
With ATIS mode enabled the radio’s region will be
fixed to the INT (international) frequency band and the
following functions are disabled:
• DSC functions
• Watch Mode
• Scan Mode
• High/low power is restricted on certain channels
From the Main menu.
1. Select Set-up.
2. Select ATIS set-up.
3. Select ATIS.
If no ATIS ID has been set then you will be requested
to enter one before ATIS mode is enabled refer to
for instructions.
4. If an ATIS ID has already been set then select On to
enable ATIS mode or Off to disable ATIS mode.
7.7 AIS receiver
Depending on variant your radio may have a built-in AIS
receiver.
With the built-in AIS receiver switched on AIS information
can be sent to a connected Raymarine® MFD using
either NMEA 0183 or SeaTalkng ®.
Note: If using the built-in AIS receiver and outputting
over NMEA 0183, ensure that the baud rate is set to
0183 High speed: Menu > Set-up > Network output .
Switching AIS on and off
From the Set-up menu: Menu > Set-up.
1. Select AIS.
Selecting AIS will switch the internal AIS receiver On
and Off.
56
81377-1-en_US_PRINT.pdf 56
12/21/2017 9:05:37 PM
Содержание Ray 90
Страница 1: ...81377 1 en_US_PRINT pdf 1 12 21 2017 9 05 36 PM...
Страница 104: ...Owner notes 81377 1 en_US_PRINT pdf 104 12 21 2017 9 05 38 PM...
Страница 105: ...Owner notes 81377 1 en_US_PRINT pdf 105 12 21 2017 9 05 38 PM...
Страница 106: ...Owner notes 81377 1 en_US_PRINT pdf 106 12 21 2017 9 05 38 PM...