Raymarine CYCLONE, Руководство по установке

Страница: 9 / 92

Chapter 1: Important information
Certified Installation
Raymarine recommends certified installation by a Raymarine approved installer. A certified
installation qualifies for enhanced product warranty benefits. Contact your Raymarine dealer for
further details, and refer to the separate warranty document packed with your product.
Warning: Product installation and operation
• This product must be installed and operated in accordance with the instructions
provided. Failure to do so could result in personal injury, damage to your vessel
and/or poor product performance.
• Raymarine highly recommends certified installation by a Raymarine approved
installer. A certified installation qualifies for enhanced product warranty benefits.
Register your warranty on the Raymarine website:
www.raymarine.com/warranty
Warning: Potential ignition source
This product is NOT approved for use in hazardous/flammable atmospheres. Do
NOT install in a hazardous/flammable atmosphere (such as in an engine room
or near fuel tanks).
Warning: Positive ground systems
Do not connect this unit to a system which has positive grounding.
Warning: Power supply voltage
Connecting this product to a voltage supply greater than the specified maximum
rating may cause permanent damage to the unit. Refer to the product’s information
label for the correct voltage.
Warning: Switch off power supply
Ensure the vessel’s power supply is switched OFF before starting to install this
product. Do NOT connect or disconnect equipment with the power switched
on, unless instructed in this document.
Caution: Power supply protection
When installing this product ensure the power source is adequately protected by
means of a suitably-rated fuse or thermal circuit breaker.
Warning: High voltage
This product contains high voltage. Do NOT remove covers or attempt to access
internal components, unless specifically instructed in the documentation provided.
Warning: Product grounding
Before applying power to this product, ensure it has been correctly grounded, in
accordance with the instructions provided.
Warning: Radar scanner safety
Before rotating the Radar scanner, ensure all personnel are clear.
Important information
9