9
The illuminator is delivered with a 35 Degree beam angle. To alter to 10
Degrees, remove the baseplate from the bottom of the product (Using a
2.5mm allen/hex key ) and remove the existing lens and then re-attach the
baseplate securely ensuring the gasket is correctly located. With no lens
insert the product produces a 10 Degree beam angle.
To alter to any other angle, remove the existing lens and insert the required
lens which will have its angle indicated on it. Ensure the baseplate is securely
re-attached to maintain waterproof integrity of the product.
The angles available as standard are: 10°x10° (No lens / diffuser in place),
35°x10° and 60°x25°. Other angles are available to order: 80°x30° and
120°x50°.
All ILS lenses will be clearly marked with the angle which they will produce
when inserted into VARIO2 POE.
Please handle ILS lenses with care – and do not touch optical film.
Only 1 ILS lens can be inserted into the product at any time. The product
cannot accommodate multiple ILS lenses at the same time.
We would recommend that power is turned off when replacing ILS lenses.
Step 5 : Configuration - Programming and Settings
Programme using optional VARIO Remote Controller (VRC) or the
manual control push buttons. – See Detailed Section
Step 6 : Security (Optional PIN protection)
Set PIN (If Required) (Can only be done with the optional VARIO Remote
Controller (VRC) – See Detailed Section
Important Note :
Ensure base plate is securely located, the gasket is
correctly located and the screws correctly fastened to ensure and
maintain IP66 rating of the product
www.ray
led
.com
Ray
LED
Tel : +
33
(0)
4 58 00 15 74
