14
PIN Function Guide
The PIN is set by using the VARIO Remote Controller (VRC). It adds an
extra layer of protection over your settings – and allows you to return to
programming mode from operating mode – without recycling the power
to your illuminators.
There are five buttons / characters on the remote that can be used for
this purpose. They are Power 5, Power 1, Min Photocell (Smallest moon),
Max Timer (Full Red Circle) & Timer Disable ( Timer Circle image with a line
through) . Note – invalid characters will not be recognised.
To create a PIN, press STATUS BUTTON for 4 seconds. LHS LED will flash
RED/GREEN. This indication will always show that you are in PIN mode.
RHS LED FLASHING RED shows that you are in PIN set mode. The number
of flashes indicates how many characters are required to complete the
PIN entry. There are four characters to be entered to successfully set up a
PIN.
As you enter the characters, the number of flashes will decrease until all
characters are entered. Note, illegal characters will not be recognised
and will not reduce the number of flashes. When the PIN is set the
illuminator will revert to Programming Mode.
Operation When a PIN is Set:
Using the remote controller you can access the illuminator settings from
operating mode by entering the PIN.
You cannot access Programming Mode by power re-cycling only.
In operating mode, if you want to go back into programming
modesimply enter your PIN. To do this, press STATUS BUTTON for 4 seconds.
LHS LED will flash RED/GREEN to show you are in PIN mode. RHS LED
FLASHING GREEN shows that a PIN has been previously set. As you input
the four correct characters the number of flashes will reduce and you will
be returned to programming mode.
www.ray
led
.com
Ray
LED
Tel : +
33
(0)
4 58 00 15 74
