C120R Operator Service Maintenance Manual
14
Safety
Gases from a battery can explode. Keep any open flames
or sparks away from the top of a battery. Do not smoke in
battery charging areas.
Never check the battery charge by placing a metal object
across the terminal posts. Use a voltmeter or a hydrometer.
Improper jumper cable connections can cause an explosion
that can result in injury. Refer to the Operation Section of
this manual for specific instructions.
Do not charge a frozen battery. This may cause an explosion.
Fire Extinguisher
Make sure that a fire extinguisher is available. Be familiar
with the operation of the fire extinguisher. Inspect the fire
extinguisher and service the fire extinguisher regularly. Obey
the recommendations on the instruction plate.
Fire Extinguisher Location
Make sure that a fire extinguisher is on the machine. Make sure
that you are familiar with the operation of the fire extinguisher.
Inspect the fire extinguisher and service the fire extinguisher.
Obey the recommendations on the instruction plate.
Mount the fire extinguisher in an easily accessible place on
the machine, for crawlers mount on the left side of the cab
behind the seat. Consult your Rayco dealer for the proper
procedure of mounting the fire extinguisher.
Ether Starting Fluid
Ether is flammable and poisonous.
Use ether in well ventilated areas. Do not smoke while you
are replacing an ether cylinder or while you are using an
ether spray.
Do not store ether cylinders in living areas or in the operator
compartment of a machine. Do not store ether cylinders in
direct sunlight or in temperatures above 49 °C (120 °F). Keep
ether cylinders away from open flames or sparks.
Dispose of used ether cylinders properly. Do not puncture an
ether cylinder. Keep ether cylinders away from unauthorized
personnel.
Do not spray ether into an engine if the machine is equipped
with a thermal starting aid for cold weather starting.
Lines, Tubes and Hoses
Do not bend high pressure lines. Do not strike high pressure
lines. Do not install any lines that are bent or damaged.
Repair any lines that are loose or damaged. Leaks can
cause fires. Consult your Rayco dealer for repair or for
replacement parts.
Check lines, tubes and hoses carefully. Do not use your bare
hand to check for leaks. Use a board or cardboard to check
for leaks. Tighten all connections to the recommended torque.
Replace the parts if any of the following conditions are present:
End fittings are damaged or leaking
Outer coverings are chafed or cut.
Wires are exposed.
Outer coverings are ballooning.
Flexible part of the hoses are kinked.
Outer covers have embedded armoring.
End fittings are displaced. Make sure that all clamps, guards,
and heat shields are installed correctly. During machine
operation, this will help to prevent vibration, rubbing against
other parts, and excessive hear.
Electrical Storm Injury Prevention
When lightning is striking in the vicinity of the machine, the
operator should never attempt the following procedures:
Mount the machine.
Dismount the machine.
If you are in the operator’s CAB during an electrical storm,
stay in the operator’s CAB. If you are on the ground during
an electrical storm, stay away from the vicinity of the machine!
While Operating the Machine
All personnel using this Machine must be trained in the
operation, safety and maintenance repair procedures.
Careless use of this Equipment could result in serious injury
or even death.
ALL PROCEDURES IN THE SAFETY AND
OPERATION SECTIONS OF THIS MANUAL MUST BE
READ AND UNDERSTOOD BEFORE STARTING THIS
MACHINE.
All operators must be wearing the proper Personal Protective
Equipment before attempting to start and operate this
machine.
Do not allow children or other spectators to standby and
watch the machine in operation.
Familiarize yourself with all of the controls in a safe environment
before starting to work with this machine.
Always have more than one person at the job site. If an
accident occurs, someone is there to assist or obtain help.
Содержание C120R
