Raw Desigh PowerPUC G4, Инструкционный лист

Страница: 1 / 26

METRICFATS.COM
Thank you for purchasing your new POWER-­‐PUC ™ Wheel Lighting Kit.
The instructional sheets that follow are thoroughly detailed and should be studied
BEFORE picking up a tool. Take your time, work safe and you will enjoy your new
POWER-PUC
™
Wheel Lights within a few hours.
ATTENTION: You should ALWAYS disconnect your battery before performing any
electrical work.
Although the following instructions show a particular make and model of bike, virtually
every installation process will be identical regardless of bike. Also, the bike shown has a
completely flat rotor. Yours may be different. Not to worry. POWER-PUCs are made to
fit your particular bike. In some cases you may find it easier to install the rear PUC on the
drive sprocket or pulley instead of the rotor (recommended location is normally marked
on packaging). As long as you have read the following instructions and are aware of the
general operation of the system, you should have no problem. Lastly, these instructions
address installation of the PUCs themselves. Because of almost limitless combinations,
detailed instructions for installation of LEDs on the wheels is impractical. However, there
may be a future article on some simple layouts. But if you have a basic knowledge of 12
volt wiring and use some common sense you should not have any issue installing LEDs.
Just remember, ANYWHERE you will be using double-stick tape, the surface
MUST be perfectly clean. Also, all wires, LEDs etc. that are on the wheels must be
thoroughly restrained.
Let’s get familiar with the kit and how it works.
(Pictures are representative only. Your PUCs may be of different sizes)