Raven RCM-Sprayer Hawkeye 2, Руководство по калибровке и эксплуатации

Страница: 76 / 124

CHAPTER 9
66 RCM - Sprayer and Hawkeye® 2 Calibration and Operation Manual
523091 .1
NCV2 calibration error
(multiple)
1. Cycle system power.
2. Edit profile.
3. Contact a local Raven dealer for additional
assistance.
523092 .31
No tip information entered
for nozzle control valve
(single)
1. Select the appropriate tip type. Refer to the
Select Tip Page section on page 22 for
additional assistance.
2. Edit the profile to reset the tip type setting for
the nozzle control system.
523093 .31
No tip information entered
for nozzle control valves
(multiple)
1. Select the appropriate tip type. Refer to the
Select Tip Page section on page 22 for
additional assistance.
2. Edit the profile to reset the tip type setting for
the nozzle control system.
523126 .13
Unable to detect RCM -
Sprayer ECU orientation
1. Check the RCM - Sprayer ECU mounting
position and verify the RCM - Sprayer ECU is
securely mounted.
2. Recalibrate the RCM - Sprayer ECU gyro.
523136
.16
Monitored flow rate is higher
than the target rate deadband
1. Reduce the equipment speed.
2. Review
Avoiding Skips with Hawkeye® 2
Nozzle Control System section on page 73.
3. Refer to the Status and Control Inputs section
on page 46 for assistance with setting or
adjusting the target rate.
4. Refer to the Alarm Settings Tab section on
page 36 for assistance with setting or
adjusting the off rate percent.
.18
Monitored flow rate is lower
than the target rate deadband
1. Increase the equipment speed.
2. Refer to the
Status and Control Inputs section
on page 46 for assistance with setting or
adjusting the target rate.
3. Refer to the Alarm Settings Tab section on
page 36 for assistance with setting or
adjusting the off rate percent.
523137 .18 Minimum flow not met
1. Activate product pump.
2. Review
Avoiding Skips with Hawkeye® 2
Nozzle Control System section on page 73.
3. Increase pump output to maintain the
minimum recommended flow rate for each
nozzle control valve.
523192
.14 New injection pump detected
1. Edit Profile or New Profile to configure the
injection pump as a product.
.15
Injection pump lost
communication
1. Verify the LEDs on the injection pump are on.
2. Check the CAN connections of the injection
device.
3. Connect the Raven Service Tool to the
ISOBUS and verify communication.
Code ID Description Recommended Actions