Raven RCM-Sprayer Hawkeye 2, Руководство по калибровке и эксплуатации

Страница: 65 / 124

NCV2 Diagnostics: 55
NCV2 DIAGNOSTICS
FIGURE 2. Advanced NCV2 Diagnostics
NOTE: Use the section and NCV2 left and right arrow buttons at the top of the NCV2 Diagnostics page to
view different NCV2s.
NCV2 READINGS
Current and Voltage. Each nozzle control valve provides the measured current, in amperes, and voltage at the
NCV2 to the RCM - Sprayer ECU for display. Current should be 0.0 Amps when selected NCV2 is off, and should
be 0.3 - 0.7 amps during normal operation. Voltage should be 10.5 - 16.0 V during normal operation.
NCV2 Duty Cycle. Each NCV2 reports the current NCV2 duty cycle over the communication network. Values
should increase or decrease as expected for changes in speed, target rate, in a turn, and when a flow offset is
enabled. Values go to zero when master switch or all boom switches are off.
Driver Temp and Micro Temp. Component temperatures on the Hawkeye® 2 nozzle control valve circuit board.
These values should be below 60°-70° C during normal operation.
System Pressure. The monitored system pressure reported by the Hawkeye® 2 spray boom pressure transducer.
Pump Duty Cycle. The current pump effort.
Runtime Hours. The total time which the NCV2 has been active.
Powered Hours. Total time the NCV2 has been powered on.
NCV2 Serial. Serial number of the NCV2 for which the information is being displayed.
Hardware Rev. This is the PCB hardware revision level of the NCV2. This is not the same as the assembly revision
level which is shown on the NCV2 label.
Program Version. The version of software loaded on each NCV2. This information may be helpful to troubleshoot
individual NCV2s or to ensure proper operation of the nozzle control system.
CAN Address. The unique location of the NCV2 on the nozzle bus.
Toggle Section/
NCV2