![background image](http://html.mh-extra.com/html/raven/precision-autoboom-g1/precision-autoboom-g1_calibration-and-operators-manual_788825007.webp)
Manual # 016-0130-019
5
enable Autoboom again so that you can time the boom once the #2
screw has been decreased past the point where it will raise the boom.
Setting the Static Pressure
The wheel should be resting on the ground.
1. Turn the Pressure Dial to zero (0).
2. Turn the #3 screw clockwise until the boom begins to rise, then stop
turning the screw.
Verifying Autoboom Setup
The calibration of the G1 system is very basic, but some verification of the correct
setup should be performed before doing any field work.
Testing the Pressure Alarms
1. Be sure Autoboom is disabled.
2. Go to the boom and physically attempt to lift it up. The alarm should
sound when you do this.
3. Repeat the test on the other boom.
Testing the Static Pressure
1. Turn the Pressure Dial on the controller to zero (0).
2. Enable the booms.
3. Go to the boom and physically attempt to lift it up. It should lift with
very little effort and should not come back down, but stay at the point
where it was lifted to.
4. Repeat the test on the other boom.
Testing the Maximum Down Speed
1. Turn the Pressure Dial on the controller to ten (10).
2. Enable the booms.
Helpful Hint:
It is recommended that you double check
the fall rate of the booms. You should begin counting
when the switch is depressed. The faster the booms fall,
the heavier the booms will be.
Important:
The boom should NOT continue to rise. If it
does, the boom static pressure is set too high. Turn the #3
screw counter clockwise a little to stop it from rising.
Содержание PRECISION AUTOBOOM G1
Страница 1: ...Calibration and Operator s Manual G1 Systems ...
Страница 2: ......
Страница 14: ......