Raven MPV-7100, Руководство по обслуживанию

Страница: 23 / 50

Remove Drive Motor Control
Work Instructions
Tools:
•
•
•
•
•
•
10mm T-Handle
8mm T-Handle
Phillips Screwdriver
13mm Wrench
10mm Wrench
8mm Wrench
Remove Drive Motor Control
POWER OFF AND REMOVE KEY.
1. Locate the bracket on the right side (if seated) of the
MPV. Use the 10mm T-Handle to remove the (2) bolts
- (1) on top (Fig. A) and (1) on bottom (Fig. B) - on
the bracket. If necessary, use a 10mm wrench on the
bottom bolt.
Locate the PCB Board. Remove the (2) bolts - top and
bottom - using the 8mm T-Handle (Fig. C). Push PCB
board gently to the side. It may be necessary to use
a 10mm T-Handle as some PCB mounting bolts are
larger.
Locate and use the 8mm T-Handle to remove the (5)
Side Panel mounting bolts (Fig. D).
Locate the Drive Motor Control and use the 10mm T-
Handle to remove (4) 10mm bolts - (2) on each side
(Fig. E).
Locate the yellow junction box below the drive motor
control and remove (2) screws using a phillips
screwdriver. Remove the cover of the junction box
(Fig. F).
Use the 10mm T-Handle to remove (3) 10mm nuts on
the junction box (Fig. G). Remove DMC wiring from
terminal posts.
Locate the 48V positive & negative wiring and plastic
Board
2.
3.
4.
5.
6.
Frame
7.
Red
Terminal Post
w/Cap
covers attached
frame (Fig. H).
to the terminal posts on top of the
Black
Terminal Post
w/Cap
DMC
Wiring
H
D e n v e r G l ob a l P r o duc t s 1 000 E as t P o we l l D r. | L inc o ln t o n , N C 2 8 09 2 U. S . A
© 2 0 1 3 D en v e r Gl o b a l P ro du c t s | RATO A ll r i gh t s r es e rv e d .
10mm Nuts
Junction Box
10mm T-Handle
G
Junction Box
Screw (x2)
Phillips
Screwdriver
F
10mm DMC
Mounting Bolts
(x4) E
5 Bolts for
Side Panel
8mm
T-Handle
D
8mm or 10mm
T-Handle
PCB
Top Bolt
Bottom
Bolt
Drive Motor
Control
C
Bottom Bolt on
Bracket
10mm Wrench
B
10mm T-Handle
Top Bolt on
Bracket
Bracket
A