Raven MPV-7100, Руководство по обслуживанию

Страница: 20 / 50

Contactor Fuses
Installation Instructions
16mm mounting screws (Fig. L).
13. On the RH contactor, use an 8mm socket and wrench to
remove the (2) M5 x 12mm mounting screws attaching
the contactor to the frame. Replace the LH screw with
an M5 x 16mm mounting screw. Locate Square Diode
and mount in the position shown with an M5 x 16mm
mounting screw (Fig. M). Green and red diode wires
should be pointing to the front of the unit.
14. Refer to Fig. N for Zip Tie placement. Use Zip Tie Gun
to tighten and trim all zip ties:
• #1 - use a 4” zip Tie to secure the J4 Jumper and
Red Deck Plug Wire from Step 3 together.
#2 - use a 4” zip tie to secure green and red Square
Diode wires together approximately 3” from diode.
#3 - use a 4” zip tie to secure green and red Square
Diode wires together approximately 6-7” from diode.
#4 - Bend excess 48V Charging Wire from Step 5
together as shown and secure with a 4” zip tie.
#5 - Use a 10” zip tie to secure the main Y Harness
and portion of 48V Charging Wire to frame as shown.
TIE
•
•
•
•
15. Re-cover the (4) terminals
terminal covers (Fig. O).
with the large red rubber
D e n v e r G l ob a l P r o duc t s 1 000 E as t P o we ll D r. | Li nc ol nt o n , N C 2 80 9 2 U. S . A
© 2 0 1 4 D en v e r Gl o b a l P ro du c t s | RATO A ll r i gh t s r es e rv e d .
Rubber Covers
O
ZI P
PLACEMENT
#1
#3
#4
#2
#5
N
RH Contactor
Remove And
Replace With
Mount Square
Longer Screws
Diode as Shown
M