24
4.
VOLUME/GRAN AND VOLUME/LIQ
The following features may be used but are not necessary for the console to
operate. These features allow the operator to monitor the amount of granular
or liquid material remaining in the truck. The key is not required to enter
these values in the console.
1)
Enter the estimated volume (tons)[MT] of material in spreader/truck box in
and volume of liquid (gal)[lit] in pre-wet tank in
. These volumes
must be re-entered each time box or tank is loaded.
5.
BLAST BUTTON
1)
Depressing the BLAST button will cause the system to go to the programmed Blast
Rate. The system will remain at the Blast Rate for as long as the button is
depressed plus the programmed Blast Time after the button is released. If
the BLAST button is used with zero speed the Console will assume a speed of 5
MPH [7 Km/hr].
2)
To display the number of times the BLAST feature was used, depress and hold
for 5 seconds until DATA display flashes. To zero this total, enter a "0".
6.
MANUAL MODE LOCK OUT
If the key switch is in the vertical position (operate mode) and the Manual
Control is off (see DATA MENU); the manual position (M) of the RATE knob will
only function under two (2) conditions:
1)
No speed (typical scenario to unload truck).
2)
No granular signal.
With the RATE knob placed to the manual position (M) the Console will default
to RATE 1 unless the above conditions exist. If the key is in the horizontal
position (program mode); OR the key is vertical and the manual control
is ON (see DATA MENU); the manual position (M)is active for all conditions. Using
the MANUAL INC/DEC switch will increase or decrease your application rate.
7.
CONTROL VALVE DELAY
Depress
until DATA display flashes. The first digit, ( X 0 0 0 ), is
the Control Valve delay digit. This feature allows the user to set a delay between
the time the MASTER is turned on and when the Console begins to control the
application rate. A value of 1-9 means a delay of 1-9 seconds respectively. A
value of 0 means no delay.
Содержание DCS 700
Страница 1: ...DCS 700 INSTALLATION AND SERVICE MANUAL ...
Страница 3: ......
Страница 4: ...Manual Rev B DCS 700 063 0171 711 7 99 016 0159 775 ...
Страница 61: ...NOTES ...
