Ravelli HR EVO 200 SMART, Инструкция по установке, использованию и техническому обслуживанию

Страница: 73 / 212

HR EVO 200-250 SMART
use and maintenance manual
Pag.73
Rev.0 03/07/2019
ENG
BOILER USE
Introduction
The pellet boiler has the advantage of combining the heat generated by the combustion of wood with the convenience of automatic
water temperature management and the possibility of weekly programming of switching on/off, as well as the connection of a
thermostat and/or chronothermostat and start-stop remote control.
For safe and reliable use:
- when lighting and using the unit the first time, unpleasant odours may be created, therefore air the room thoroughly;
- the hopper must only be filled with good quality pellets; make sure the bag does not come into contact with the hot surfaces
of the boiler;
- do not put any fuel other than the prescribed pellets in the hopper;
- the unit must not be used as a waste incinerator;
- the boiler must only operate with the fire door always closed.
- the fire and ash door seals must be checked periodically to prevent air from entering;
- to ensure thermal efficiency and correct operation it is necessary to clean the brazier every time pellets are loaded;
- when lighting the boiler for the first time, allow it to heat up gradually by setting low operating temperatures (see the section
on temperature setting);
- during lighting, operation and shutdown, the boiler may creak a little due to the heat expansion.
Description of control panel
The control panel comprises a backlit LCD, on/off button ‘P4’, SET/MENU button ‘P3’, four menu buttons ‘P1’, ‘P2’, ‘P5’, ‘P6’, and
seven boiler operation status LEDs.
The panel enables boiler lighting and shutdown, adjustment during operation and the setting of management and maintenance
programs.
The display shows all the information on boiler operation status.
To access the menus, proceed as follows:
- press the SET button ‘P3’;
- press the buttons ‘P5’, ‘P6’ to scroll the various menus;
- press one of the increase/decrease buttons ‘P1’, ‘P2’, to set the required parameter;
- press the SET button ‘P3’ to confirm the parameter value.
On accessing the menu it is possible to obtain the various types of displays and make settings, depending on the access level.
Status indicators Backlit LCD
Power adjustment
button
Menu/selection
button
Temperature
adjustment
button
On - selection
button