Rauch AXEO 2.1, Инструкция по эксплуатации

Страница: 61 / 136

Machine settings
53
7
7.3 Adjusting the application rate
You can set the application rate via the metering slide opening at the numeric
scale on the scale plate.
For this purpose, move the pointer to the position specified beforehand in the fer-
tiliser chart or from a calibration test. This is the
Open stop position the slide is
hydraulically or electrically positioned at (depending on the version).

Adjusting in the direction of higher values opens the metering slider.

Adjusting in the direction of lower values closes the metering slider.
NOTICE
The Q winter spreader is fitted with an electronic metering slide actuator for set-
ting the application rate.
The electronic metering slide actuator is described in a separate operator's man-
ual for the QUANTRON-K2 control unit. This operator's manual is supplied with
the QUANTRON-K2 control unit.
n
WARNING
Risk of crushing and shearing in the area of the spreading
quantity adjustment!
When untightening the setscrew of the application rate limit stop,
the slide lever may move unexpectedly against the end of the
guide slot and cause severe injuries to the fingers.
 Only untighten the setscrew of the application rate limit stop
if the metering slide is closed.
 Do not place fingers in the guide slot of the application rate
adjustment unit.
 If the machine is parked on its own (without tractor), fully
open the metering slide. Hydraulic cylinder at limit stop,
return spring still tensioned.
n
CAUTION
Material damage caused by an insufficient metering slide
opening
Insufficient opening of the metering slide can cause blockages and
can damage the spreading material. Agitator wear increases.
 Always select an adequate opening for the metering slide,
at which the spreading material flows out in an unobstructed
manner.