Rauch AXEO 2.1, Инструкция по эксплуатации

Страница: 54 / 136

Commissioning 6
46
6.9 Filling the machine
Instructions on filling the machine

Close the metering slide.

Only fill the machine when it is attached to the tractor. Make sure that the
tractor is standing on level and solid ground.

When determining the maximum admissible loading amount, consider the
specific weight of the spreading material (kg/l).
-
The weight of the spreading material depends on the type of spreading
material (e. g. grit, sand, fertiliser) and its state (dry, wet).
- see chapter 13: Axle load calculation, page 119

Secure the tractor against rolling away. Apply the handbrake.

Use suitable auxiliary equipment for filling: e.g. front-end loader, auger, silo.

When manually filling it (e.g. loading it with big bags), use suitable steps.

Fill the machine up to the edge maximally.
n
DANGER
Danger of injury due to running engine
Working on the machine while the motor is running may result in
serious injury caused by mechanical components and escaping
spreading material.
 Never fill the machine while the tractor motor is running.
 Switch off the tractor engine.
 Remove the ignition key.
 Send third persons out of the danger area. Refer to “Hazard
zone“ on page 10 .
n
CAUTION
Inadmissible overall weight
If the permissible total weight is exceeded, this will affect the oper-
ating and road safety of the vehicle (machine and tractor) and may
cause serious damage to the machine and the environment.
 Before you start filling, calculate the amount you can load.
 Comply with the permissible overall weight.