R&S M3SR 4100 Series, Руководство по эксплуатации, Страница: 633 / 706

Operating Manual 6175.4760.02 – 01 5.87
M3SR Series 4100 Editing the Multicast Routing Table
The blue bar 'Multicast Routing' shows the index of the currently visible entry (n) and the total
number of entries (m) in the form n/m. One entry consists of the parameters
• Sender IP Address
• Group IP Address
• Direction
• TTL
If 'Insert Address' or 'Edit Address' is pressed, an editor will appear.
Enter or alter the first parameter (Sender IP Addr). Use the keypad or knob to set the first
octet. Then press the ‘point’ key at the keypad to enter the next octet (if you made a mistake
you can press the ‘point’ key several times until you are at the entry which has to be correct-
ed). If the IP address is complete, press 'ENT'. The editor for the group IP address opens;
proceed the same way as with the Sender IP Addr. After pressing 'ENT' the editor for the
direction opens. After pressing 'ENT' the editor for TTL opens. After the TTL was entered,
press 'ENT' again. The entry is now in the routing table.
The direction has to be set by entering a number:
The routing direction for multicast packets is from input to output interface.
0 ETH -> AIR (Ethernet to Air)
1 AIR -> ETH (Air to Ethernet)
2 PPP -> AIR (Point-to-Point Protocol to Air)
3 AIR -> PPP (Air to Point-to-Point Protocol)
4 AIR -> AIR (Air to Air)