Water In Fuel Message
If a Water In Fuel message or
indicator appears in the cluster and a chime
sounds five times, the fuel/water separator will need to be drained immediately to
prevent engine damage.
Refer to “Draining Fuel Water Separator” in this guide for draining instructions or see
your dealer.
DIESEL FUEL FILTER/WATER SEPARATOR
Draining Fuel/Water Separator
If the “Water in Fuel” indicator light
is illuminated and an audible chime is
heard five times, you should stop the engine and drain the water from the separator.
The drain plug is located on the bottom of the Fuel Filter and Water Separator
assembly which is located above the rear axle next to the fuel tank.
Loosen the drain plug (located on the bottom filter assembly) then turn the ignition
switch to the ON/RUN position to allow any accumulated water to drain.
When clean fuel is visible, close the drain and switch the ignition to the OFF position.
Refer to the Diesel Supplement at www.ramtrucks.com/en/owners/manuals for fur-
ther details.
Fuel Filter Replacement
1. Ensure engine is turned off.
2. Place drain pan under the fuel filter assembly.
3. Open the water drain valve, and let any accumulated water drain.
4. Close the water drain valve.
5. Remove bottom cover using a strap wrench. Rotate counterclockwise for removal.
Remove the used o-ring and discard it.
6. Remove the used filter cartridge from the housing and dispose of according to
your local regulations.
7. Wipe the sealing surfaces of the lid and housing clean.
8. Install new o-ring back into ring groove on the filter housing and lubricate with
clean engine oil.
NOTE:
The WIF (Water In Fuel) sensor is re-usable. Service kit comes with new o-ring for
filter canister and WIF (Water In Fuel) sensor.
1 5 0 0 3 . 0 L D I E S E L
232
Содержание 1500 2017
Страница 7: ...INTRODUCTION WELCOME 5 ...
Страница 369: ...NOTES 367 ...
Страница 370: ...NOTES 368 ...