KEYLESS ENTER-N-GO — IGNITION
Starting
With a valid Keyless Enter-N-Go key fob
inside the vehicle:
1. Shift the transmission into PARK (P).
2. While pressing the brake pedal, push
the ENGINE START/STOP button
once. If the engine fails to start, the
starter will disengage automatically
after 10 seconds.
3. To stop the cranking of the engine
prior to the engine starting, push the
button again.
NOTE:
In case the ignition switch does not change with the push of a button, the key fob may
have a low or dead battery. In this situation, a back up method can be used to operate
the ignition switch. Put the nose side of the key fob (side opposite of the emergency
key) against the ENGINE START/STOP button and push to operate the ignition
button.
Stopping
1. Bring the vehicle to a complete stop.
2. Shift the transmission to PARK (P).
3. Push the ENGINE START/STOP button once. The ignition will return to the OFF
mode.
NOTE:
If the transmission is not in PARK and the vehicle is in motion, the ENGINE
START/STOP button must be held for two seconds with the vehicle speed above
5 mph (8 km/h) before the engine will shut off.
For further information and applicable warnings and cautions, please refer to your
Owner’s Manual at www.ramtrucks.com/en/owners/manuals.
Start/Stop Button
G E T T I N G S T A R T E D
15
Содержание 1500 2017
Страница 7: ...INTRODUCTION WELCOME 5 ...
Страница 369: ...NOTES 367 ...
Страница 370: ...NOTES 368 ...