RAM 1500 2017, Руководство пользователя

Страница: 219 / 372

Divider Position
There are 11 divider slots along the bed inner panels which allow for various positions
to assist in managing your cargo.
To install the bed extender into a divider position perform the following:
1. Make sure the center handle is unlocked using the vehicle key and rotate the
center handle vertically to release the extender side gates.
2. With the side gates open, position the extender so the outboard ends align with
the intended slots in the sides of the bed.
3. Rotate the side gates closed so that the outboard ends are secured into the
intended slots of the bed.
4. Rotate the center handle horizontally to secure the side gates in the closed
position.
5. Lock the center handle to secure the panel into place and assist against theft.
Extender Position
The bed extender will add an additional 15 inches (38 cm) in the back of the truck
when additional cargo room is needed.
To install the bed extender into the extender position, perform the following:
1. Lower the tailgate.
2. Make sure the center handle is unlocked and rotate the center handle vertically in
order to release the extender side gates.
3. Fit the end of the side gate ends onto the pin and handle.
4. Rotate the handles to the horizontal position to secure into place.
Bed Rail Tie-Down System
There are two adjustable cleats on each side of the bed that can be used to assist in
securing cargo.
Each cleat must be located and tightened down in one of the detents, along either
rail, in order to keep cargo properly secure.
• To move the cleat to any position on the rail, turn the nut counterclockwise,
approximately three turns. Then, pull out on the cleat and slide it to the detent
nearest the desired location. Make sure the cleat is seated in the detent and
tighten the nut.
• To remove the cleats from the utility rail, remove the end cap by pushing up on the
locking tab, located on the bottom of the end cap. Slide the cleat off the end of the
rail.
U T I L I T Y
217