Chapter 1: Introduction
1.2.10 Enclosure DIP Switch
Figure 1-13: Enclosure DIP Switch
A DIP switch is located on the upper left corner of enclosure rear panel, above the
cooling module. The six (6) switches marked from 1 to 3 and 6 to 8 are reserved.
The switches marked 4 and 5 are for adjusting Fibre Channel link speeds and
enabling/disabling the internal hub bypass functionality.
The configuration options
for setting the DIP switch is fully discussed in
Section 4.3
.
1.3. Subsystem Monitoring
The FALCON RAID subsystem comes with several monitoring methods to give
you constant updates on the status of the system and its individual components.
The following monitoring features are included in the subsystem.
1.3.1 I
2
C bus
The following subsystem elements interface to the RAID controller over a non-user-
serviceable I
2
C bus:
Disk drives (drive failure output)
PSU modules
Cooling modules
Temperature sensors
Subsystem Monitoring
1-13