RADWAG PUE HX5.EX, Руководство пользователя программного обеспечения

Страница: 71 / 96

71
•
Visualisation of mass value higher than the value of
[DT1]
threshold and
lower than the value of
[DT2]
threshold:
•
Visualisation of mass value higher than the value of
[DT2]
threshold:
•
Upon exceeding the value of fast dosing threshold, fast dosing outputs are
activated.
•
Upon exceeding the value of dosing threshold, dosing outputs are
activated and
PS=OK
process status is displayed.
•
In case of active time delay, countdown of declared time starts.
•
After countdown completion,
PS=Completed
status is displayed (process
completed). Blinking pictogram is turned off.
24.4. Manual Dosing Procedure
•
Save general parameters of Dosing mode to scale memory, the
parameters are to be found upon pressing a key to which pictogram
is assigned.
•
Press key to which pictogram (process start) is assigned, scale keypad
is locked except for - stop, - pause, - breakdown keys.
When:
1. Dosing outputs are declared incorrectly (e.g. lack of active MIN or MAX
outputs) the following message is displayed:
<Dosing outputs
determined incorrectly>
, next the process is cancelled.
2. Mass value on the weighing pan (in silos) is greater than declared
<Auto
threshold>
value or when the weighing result is unstable then the
following message is displayed:
Unstable weighing result or mass
above „Auto threshold”
. The process status changes to
PS=Pause
and
remains so until stable weighing result is obtained and/or weighing pan
emptied.
•
Upon process start, bar graph of dosed material mass is displayed with
the following data:
DT1=1600g
DT2=1800g
DT1=1600g DT2=1800g