Performing the MCU Initial Configuration | 51
RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7
Configuring Security Access Levels for the SCOPIA Elite MCU
The SCOPIA Elite MCU offers configurable security access levels that enable and disable SSH, FTP,
SNMP and ICMP (ping) protocols.
By default, the security access level is set to Standard. It is recommended to set your security
access level to Maximum (which disables these protocols), except for the following situations:
•
If you are performing either debugging or troubleshooting operations, SSH should be enabled.
•
If you are customizing your language settings, FTP should be enabled.
•
If you would like control or error response messages to be sent, ICMP (ping) should be enabled.
•
If you are performing configuration procedures or would like to receive traps, SNMP should be
enabled.
Note:
You can view trap events in the Events tab of the web user interface.
Procedure
Step 1
Access the MCU security settings by selecting Configuration > Setup.
Step 2
Locate the Security section.
Step 3
Select the access level from the Security Mode list (see
Figure 5-20 on page 51
).
Table 5-2
lists
the protocol status when each security access level is applied.
Figure 5-20
Security Access Level Settings
Table 5-2
MCU Security Access Levels
Step 4
Select Apply.
Security Access
Level
SSH
FTP
SNMP
ICMP (ping)
Standard
Enabled
Enabled
Enabled
Enabled
High
Disabled
Disabled
Enabled
Enabled
Maximum
Disabled
Disabled
Disabled
Disabled
