Performing the MCU Initial Configuration | 36
RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7
Configuring Protocols for the MCU
Set the MCU protocols by configuring it to work either with the H.323 gateway or with the SIP
Proxy Server, or with both. You can change the protocol-related settings at any time without
resetting the MCU.
•
Configuring H.323 Protocol Settings ........................................................ page 36
•
Configuring SIP Server Settings .............................................................. page 37
Configuring H.323 Protocol Settings
You can configure the H.323 protocol settings to set how the MCU and the gatekeeper interact.
Note
•
Changing gatekeeper settings does not reset the MCU, but might disconnect active calls.
•
You do need to reset the MCU to disable support for the H.323 protocol.
Procedure
Step 1
Select Configuration
.
Step 2
Select Protocols.
Step 3
Locate the H.323 section.
Figure 5-5
H.323 protocol section of the Protocols tab
Step 4
Select H.323 to enable the MCU to operate with the H.323 protocol.
Step 5
Enter the IP address and port number for the gatekeeper.
The default port is 1719.
Step 6
Select Apply.
Step 7
Check the MCU status using the MCU Administrator interface:
a.
Enter the MCU IP address or the MCU name into the Internet browser.
b.
Enter the Administrator user name and password in the appropriate fields and select Go.
The default global user name is admin. The default password is password.
The Status tab of the Administrator interface opens.
c.
Locate the Status Map section. This section is a graphic representation of the MCU chassis
