Performing the MCU Initial Configuration | 47
RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7
Configuring the UDP Port for RAS on the SCOPIA Elite MCU
The SCOPIA Elite MCU 5000 Series has designated port 1719 for RAS. You can configure a different
port to use RAS (for example, if port 1719 is busy). Port 1719 is also used to communicate with
the gatekeeper (to configure the UDP port for the gatekeeper, see
“Configuring the UDP Port for
the Gatekeeper on the SCOPIA Elite MCU” on page 48
).
Note:
If you close port 1719, you must configure another port for both RAS and the gatekeeper. If you
configure a different port for RAS, you do not need to configure a different port for the gatekeeper.
Procedure
Step 1
Navigate to the MCU Advanced Commands section by doing the following:
a.
Select the
icon.
b.
Select Advanced parameters.
c.
Locate the H323 RAS port number in the Name column (see
Figure 5-16 on page 47
).
Figure 5-16
RAS Port Configuration
Step 2
Select the icon in the Review column.
Step 3
Enter the port value in the H323 RAS port number field.
Step 4
Select Apply.
Step 5
Select Close.
