35
• To ease the learning curve, elevator and aileron may be set to the NORM or FUNC mode, with the other
channels set to OFF and controlled by the instructor.
NOTE:
• NEVER turn on the student transmitter power.
•ALWAYS set the student transmitter modulation mode to PPM.
• BE SURE that the student and instructor transmitters have identical trim settings and control motions.
Verify by switching back and forth while moving the control sticks.
• FULLY extend the instructor's antenna. Collapse the student's antenna. (Except 2.4GHz)
• When the TRAINER function is active, the snap roll function is deactivated. Other functions, such as
IDLE-DOWN and THR-CUT, which have been assigned to the same switch, are not deactivated. Always
double check your function assignments prior to utilizing the TRAINER function.
•When you select a different model, the TRAINER function is deactivated in the current model for safety
reasons.
2.15 Logic Switch Selection (LOGIC SW)
The various functions in the AT9S Pro can be selected by switch..
The Logic switch can be assigned to the functions as following: THR-CUT, IDLE DOWN, AUX-CH, TIMER,
PROG. MIX, AIRBRAKE, ELEV-FLAP, and AILE-FLAP. The logic switch can activate functions by two
switches combination. The 2 types of logic, either AND or OR, can be selected.
Adjustability:
• Three logic switches can be used. (LSW1, LSW2, and LSW3 )
• SW (1): Any SWICH A-H or THRSTKS, SW (2): Any SWICH A-H
Goals
Steps
Inputs
Turn on the TAINER system
and set up so student
has :fully functional control of
aileron and elevator to
support FLAPERON
&AILERON; normally control
of rudder to allow lowered
travel; and no throttle channel
control(with the instructor for
safety)
Open BASIC menu, then Open
TRAINER
for 1s .(If ADVANCE
again) .
to TRAINER ,PUSH
Activate TRAINER
PUSH,
to PUSH
Choose desired channels and
proper training types
past AIL and ELE(default FUN)
to THR,PUSH
，
to OFF, PUSH
to RUD, PUSH,
to NORM,PUSH
Close
Test student radio function prior to attempting to fly!
