47
response, allowing the flaps/ailerons/elevator to all reach their desired end point together. A setting of 100%
slows the servo to take approximately one second to travel the prescribed distance. (GLID: B.FLY-ELEV
function)
• Adjustable in flight (ACRO): Using the aileron (when AILE-DIFF or FLAPERON is activated) and elevator
trim lever in flight can be set to adjust the aileron and elevator settings in your airbrake rather than adjusting
the model's actual aileron and elevator trim. This allows easy adjustment for any ballooning while in flight.
When the airbrake switch is moved to off the trim is again adjusting the normal elevator trim.
• Channels controlled: Elevator, twin ailerons and flap may be set independently in AIRBRAKE, including set
to 0 to have no effect.
• If FLAPERON is active, the travel of the ailerons can be independently adjusted for the servos plugged into
CH1 and CH6. The flap choice has no effect on the FLAPERON.
• If AIL-DIFF is active, then CH1 and CH7 may be independently adjusted.
• Normally both ailerons are raised equally in AIRBRAKE, and the elevator motion is set to maintain trim when
the ailerons rise. Different amounts may be set for each aileron to correct for torque reactions and other
unique characteristics of the model.
Be sure you understand what dropping ailerons will do when in AIRBRAKE BUTTERFLY. Along with
creating an enormous amount of drag (desirable for spot landings), this also creates "wash-in", a higher angle
of attack where the ailerons are, and encourages tip stalling.
If you are using this for aerobatic performance and not "sudden stops", consider raising the ailerons and
dropping the flaps instead as shown in the diagram above.
Goals
Steps
Inputs
Activate AIR-BREAK
on a FLAPERON.
Mode. Adjust the
FLAPERON travel to
75%, with negative
elevator(push) of 25%.
Confirm FLAPERON is
active.
See FLAPERON instructions.
Open AIR-BREAK.
to BASIC .
again to ADVANCE
to
AIR-BREAK. PUSH.
Activate the function
SW C in up position
to MIX. PUSH
to OFF
Adjust the travels as
needed. (Ex: Ailerons
each 75%,
Elevator-25%)
to AIL1.PUSH.
to +75%
，
PUSH
to ELEV.PUSH.
to -25%
，
PUSH
to AIL2.PUSH.
to+75%
，
PUSH
Optional: delay the
speed of the elevator
servo.
to delay-ELEV. PUSH.
to 25%
，
PUSH
Optional: change the
mixing from full amount
upon switch to
proportional to the
Throttle Stick’s proximity
to idle.
to MODE.PUSH.
to Linear(0%)
，
PUSH.
Throttle Stick to desired 0 point.
for 1sec.till beeps
(Display changes if new setting is different from prior
Close
