Radiolink Electronic Ltd
55
Adjust travels as needed to
match model’s recommended
throws (usually listed as high
rates).
In BASIC menu choose
END POINT.
to END POINT.
Adjust the servos’ end
points. (Ex: flap servo).
Close the function.
to FLAP
VR(A).
，
to desired travel.
VR(A).
，
to desired travel.
Repeat as needed.
Choose D/R,EXP
to D/R,EXP
Set up dual/triple rates and
exponential (D/R, EXP).
(Note that in the middle of the
left side of the screen is the
name of the channel and the
SWITCH position you are
adjusting. Two or even three
rates maybe set per channel by
simply choosing the desired
SWITCH and programming
percentages with the SWITCH in
each of its 2/3 position.)
Choose the desired
control, and set the first
(Ex: high) rate throws and
exponential.
to CH
，
to CH2(ELEV).
A to UP position. Screen reads ELEV [UP]
to D/R
Elevator Stick.
,
to set
.
Elevator Stick.
to set.
（
Normally the same for both direction
）
to EXP
Elevator Stick
to set
Elevator Stick
to set
Set the second (Ex: low)
rate throws and
exponential.
to D/R
,
A to down position. Repeat
above to set low rate.
Optional: change dual
rate SWITCH assignment.
Ex: elevator to SWITCH
G with 3 positions.
to SW
,
to G,
G to center.
Repeat steps above to set 3rd rate.
Move flap control from the (VR
(A)) dial to the left slider.
[VR(D)](AUX-CH) .
In the BASIC menu, open
AUX-CH.
to AUX-CH
Choose CH5. Change
primary control to VR(D).
Change other channels as
needed.
to CH5
,
to VR(D)
。
Repeat steps above to set other channels.
Close
4.2 SET GLID TYPE
TYPE: (GLID 1A+1F), GLID (2A+1F), GLID (2A+2F)
