Radiant RK 100, Инструкция по эксплуатации

Страница: 67 / 72

MAINTENANCE INSTRUCTIONS
RK 100 - RAD - ING - MAN.INST - 1311.1 - DIGITECH CS MIAH4
63
6.8 Troubleshooting
To display the last 5 errors, keep pressed the ‘ ’ INFO button, in OFF mode position, for 5 seconds. The
errors number will appear in chronological order (-1- = first fault… -5- = last fault). Use ‘ ’ and ‘ ’ buttons
of Heating Temperature setting, to scroll the list of saved errors. To reset the errors list press the‘ ’
RESET button. Press the ‘ ’ INFO button to exit the errors display mode.
ERROR
CODE
PROBLEM POSSIBLE CAUSE REMEDY RESET
E01
IONISATION
PROBLEM
WITHOUT FLAME IGNITION
a. NO GAS.
b. IGNITION ELECTRODE
BROKEN OR EARTHED.
c.
GAS VALVE
MALFUNCTION.
d. IGNITION SEQUENCE
SET TOO LOW.
WITH FLAME IGNITION
e. POWER SUPPLY LINE
AND NEUTRAL CABLES
REVERSED.
f.
IONISATION ELECTRODE
MALFUNCTION.
g. IONISATION ELECTRODE
CABLE DISCONNECTED.
a. CHECK MAINS GAS
SUPPLY.
b.
REPLACE PART.
c.
REPLACE PART.
d. SET THE IGNITION
SEQUENCE.
e. CONNECT THE
BOILER PROPERLY.
f. REPLACE PART.
g.
CONNECT THE
IONISATION
ELECTRODE CABLE.
Manual Reset
(press the ‘ ’
Reset button)
E02
SAFETY
THERMOSTAT
TRIPPED (95°C)
h. THERMOSTAT
MALFUNCTION OR OUT
OF CALIBRATION.
i. THERMOSTAT CABLE
DISCONNECTED.
i. REPLACE PART.
j.
CHECK THE WIRING.
Manual Reset
(press the ‘ ’
Reset button)
E03
102° C THERMO
FUSE TRIPPED
k. THERMO FUSE BROKEN.
l.
THERMO FUSE CABLE
OR POWER SUPPLY
DISCONNECTED.
k. REPLACE PART;
l.
CHECK THE WIRING
AND THE POWER
SUPPLY
CONNECTION.
Manual Reset
(press the ‘ ’
Reset button)
E04
NO WATER IN
THE SYSTEM
m. INSUFFICIENT WATER
PRESSURE IN THE
SYSTEM (STOPS AT 0.3
BAR).
n. WATER PRESSURE
SWITCH CABLE
DISCONNECTED.
o.
WATER PRESSURE
SWITCH MALFUNCTION.
m. FILL THE SYSTEM.
n. CHECK THE WIRING.
o.
REPLACE PART.
Automatic
E05
HEATING
SENSOR
p.
SENSOR MALFUNCTION
OR OUT OF
CALIBRATION
(RESISTANCE VALUE 10
kOhms AT 25 °C).
q. SENSOR CABLE
DISCONNECTED OR
WET.
p.
REPLACE PART.
q. CHECK THE POWER
SUPPLY
CONNECTION.
Automatic