Radiant RK 100, Инструкция по эксплуатации

Страница: 53 / 72

REGULATION INSTRUCTIONS
RK 100 - RAD - ING - MAN.INST - 1311.1 - DIGITECH CS MIAH4
49
PARAMETER P23 – MODULATING PUMP MINIMUM SPEED
N.B. w/modulating pump and return temperature sensor connected only
This parameter is used to set the minimum modulating pump speed
during a heating mode request.
To enter the parameters menu, follow the previously described
procedure (
see paragraph 5.2 ‘Accessing the parameters menu’
- steps
1-4).
5. Use ‘ ’ and ‘ ’ buttons
S
symbol side to modify the value of
the parameter within the prescribed limits (displayed in percentage):
min = 50 %
max = 70 %
6.
Press mode selection button ‘ ’ to confirm and to render the
new parameter operative.
7. To exit from the parameters menu, press simultaneously ‘ ’ and
‘ ’ buttons.
PARAMETER
P24 – MODULATING PUMP MAXIMUM SPEED
N.B.
N.B. w/modulating pump and return temperature sensor connected only
This parameter is used to set the maximum modulating pump speed
during a heating mode request.
To enter the parameters menu, follow the previously described
procedure (
see paragraph 5.2 ‘Accessing the parameters menu’
- steps
1-4).
5. Use ‘ ’ and ‘ ’ buttons
S
symbol side to modify the value of
the parameter within the prescribed limits (displayed in percentage):
min = 70 %
max = 100 %
6.
Press mode selection button ‘ ’ to confirm and to render the
new parameter operative.
7. To exit from the parameters menu, press simultaneously ‘ ’ and
‘ ’ buttons.
PARAMETER
P25 – ∆ T TIMING T° FLOW / T° RETURN
N.B. w/modulating pump and return temperature sensor connected only
This parameter is used to set the timing response of the modulating
pump.
To enter the parameters menu, follow the previously described
procedure (
see paragraph 5.2 ‘Accessing the parameters menu’
- steps
1-4).
5. Use ‘ ’ and ‘ ’ buttons
S
symbol side to modify the value of
the parameter within the prescribed limits (displayed in seconds):
min = 20
max = 100
6. Press mode selection button ‘ ’ to confirm and to render the
new parameter operative.
7. To exit from the parameters menu, press simultaneously ‘ ’ and
‘ ’ buttons.
P30
20
P30
30
P24
80
P24
100
60
P23
75
P23
S
S
S
S
S
S