Rabe KORMORAN PL V 180, Руководство по эксплуатации

Страница: 4 / 70

KORMORAN PL V 180 / PL VHA 180
QUICK START
9901.00.23EN00 - 01/2016
20.
Check the side alignment (plumb line).
-
The legs must be at right angles to the ground (adjust the
inclination screws).
21.
Close the offset again before you turn the implement.
-
6SULQJPRXQWHGIURQWD[OHORZHUHG
22.
Check the side alignment (plumb line).
-
The legs must be at right angles to the ground (adjust the
inclination screws).
23.
Close the offset again before you turn the implement.
Ploughing inside the track
24.
Check the offset cylinder's position.
25.
Adjustment wheels and plumb line adjustment screw.
-
Ploughing selectively inside the track: Retain the same
FRQ¿JXUDWLRQDVZKHQSORXJKLQJRXWVLGHWKHWUDFNDGMXVWPHQW
wheels at the front).
-
3ORXJKLQJIRUDQH[WHQGHGSHULRGLQVLGHWKHWUDFN5HPRYHWKH
front adjustment wheels. Return the plumb line's adjustment
screws to the top.
1st pass
26.
Place the implement on the ground.
27.
Use the support bolt to adjust the working depth
setting on the rear wheel block and the tractor's lifting
arm height.
2nd pass
28.
Use the support bolt on the rear wheel to adjust the
GHSWK¿QHO\
29.
Align the implement horizontally lengthways.
-
Balance the wheel's height adjustment and the tractor's lifting
height.
-
Bolt on the top link: This must be higher on the implement side
than on the tractor side. Adjust the length so that the bearing
rail is parallel to the ground and at the desired working depth.
30.
Check the side alignment (plumb line).
-
The clamping devices must be at right angles to the ground
(adjust the inclination screws).
31.
Adjust the width of the 1st track.
-
Adjust the offset setting jig's opening so that the 1st plough
body works at the same width as the others.
Maintenance
32.
Maintain the implement in the same way as every
other agricultural device, follow the recommendations
in the manual.