TEX1002LCD
9
/ 26
User Manual
Rev. 1.0 - 22/08/14
5. Quick guide for installation and use
This section provides a step-by-step description of equipment installation and
configuration procedure. Follow these procedures closely upon first power-on
and each time any change is made to general configuration, such as when a new
transmission station is added or the equipment is replaced.
Once the desired configuration has been set up, no more settings are required
for normal operation; at each power-up (even after an accidental shutdown),
the equipment defaults to the parameters set during the initial configuration
procedure.
The topics covered in this section are discussed at greater length in the next
sections, with detailed descriptions of all hardware and firmware features and
capabilities. Please see the relevant sections for additional details.
IMPORTANT:
When configuring and testing the transmitter in which the equipment
is integrated, be sure to have the Final Test Table supplied with the equipment ready
at hand throughout the whole procedure; the Final Test Table lists all operating
parameters as set and tested at the factory.
5.1 Preparation
5.1.1 Preliminary checks
Unpack the transmitter and immediately inspect it for transport damage. Ensure
that all connectors are in perfect condition.
The main fuse can be accessed from the outside on the rear panel. Extract the fuse
carrier with a screwdriver to check its integrity or for replacement, if necessary.
The following fuses are used::
TEX1002LCD
@ 230 Vac
MAINS FUSE
(2x) F 10A type 6x30
Table 5.1:
Fuse
The mains power supply unit is the full-range type and requires no voltage
setup.
Provide for the following (applicable to operating tests and putting into service):
√
Single-phase 230 (-15% / +10%) Vac mains power supply, with adequate earth
connection.
