TEX1002LCD
21
/ 26
User Manual
Rev. 1.0 - 22/08/14
Menu 12
FSK
Enables / disables FSK code transmission.
Cod
Shows the Morse code sent normally..
5.5.1.1 Changing the ID code
User may change the FSK code used as a station identifier at any time.
This procedure requires:
• 1 RS232 male-female cable;
• Hyper Terminal interface (make sure it has been installed together with
Windows®) or equivalent serial communication software
A brief description of the procedure is provided below:
• Connect the PC serial port COM to the SERVICE connector on the rear panel
of
TEX2500LCD
using a standard Male DB9 - Female DB9 serial cable.
• Power on the transmitter;
• Launch the serial communication software;
• Set communication parameters as follows:
Baud Rate:
19200
Data Bit:
8
Parity:
None
Stop Bit:
1
Flow control:
None;
• Activate Caps-Lock through the communication software and send string CODE
followed by the 6-character station ID code followed by Enter.
NOTE: To be treated as valid, the code must be made up of 6 alphanumeric
characters and must contain no blank spaces; if acknowledged as valid, code is
echoed back to the terminal, illegal codes are not echoed.
5.5.2 Power UP/DOWN Option
The Power UP/DOWN option modifies the signal receive function for the signals
present at the telemetry connector.
